Carbon Peeling by Laser

Carbon peeling is a procedure made with Q-switch Nd Yag laser that is based on the removal of the carbon mixture applied to the skin with laser.

The procedure of the laser together with the carbon mixture enhances the effect of heat and sound waves emitted by the laser. With this effect, the production of collagen in the skin increases, the skin rejuvenates, the pores shrinh and tighten, a smoother and healthier skin is observed.

How does it work?

Depending on the disintegrating effect of the Q-switched Nd: YAG laser on melanin pigment in the skin, the skin tone is brightened, face is lightened and skin spots are visibly reduced.

How is it applied?

Before applying the laser, a mixture of carbon is applied to the skin surface. The carbon mixture is allowed to stand for 15 minutes, being absorbed by the pores. The skin surface is then scanned for approximately 10 minutes and the application is terminated.

Is it painful?

No it is not. Very slight redness, rarely stinging and burning sensation can occur.

As a result;

Skin oil decreases,
Pores shrink,
The skin lightens, shines and rejuvenates,
Removes mild skin spots,
Helps remove light fine hairs.

Immediately after application, there is a clear illumination and shine on the skin. After 1 week skin lubrication is reduced. Narrowing of the pores, skin rejuvenation and stain removal effect occurs in 2-4 months. Although it varies according to the skin type, the positive effects of carbon peeling treatment, which is applied in 4-8 sessions, continue for 1-1.5 years.

No skin peeling is seen after application. The redness, stinging and burning sensation that may occur is reduced within a few hours.

What to pay attention to:

Sunscreen and moisturizing creams should be used immediately after the application of carbon peeling.

It can be used in combination with methods such as mesotherapy, PRP, tone stabilizing hyaluronic acid and needle radiofrequency. Combined treatments strengthen the positive effects of carbon peeling.